Directions: Read and follow directions carefully. Dunham’s Professions Moisture Cure Urethane High Gloss should be stirred. Surface must be clean, dry free from wax, grease, etc. Old finishes in poor condition must be completely removed. Test this product in a small area for adhesion and lifting before application. Apply by brush, roller or applicator. Material, room temperature and should be 65 degrees or above. Provide adequate ventilation during and after application. New and previously finished wood must be uniformly sanded. Unsealed and untreated concrete must cure at least 30 days acid etch and rinse with water to neutralize. Allow to dry thoroughly. Apply with the grain. Avoid going back over wet surface. Allow to cure 4-6 hours apply each additional coat desired approximately 6 hours after application of the base coat. Surface is dry to touch in approximately 2 hours.

This will cover approximately 400-500 square feet per gallon.

Clean equipment immediately. Use xylol. This product is not recommended to be used on stained floors.